Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Whats the standard thickness for a metal control panel?  (Read 1094 times)

0 Members and 1 Guest are viewing this topic.

Hoagie_one

  • Trade Count: (+6)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 3062
  • Last login:September 04, 2020, 12:36:28 pm
  • Um....whats a cabinet
Whats the standard thickness for a metal control panel?
« on: February 01, 2005, 10:47:17 am »
I was thinking 16 Ga, but maybe 18Ga.  Dunno.

Stingray

  • Official Slacker - I promise to try a lot less
  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 10463
  • Last login:April 08, 2021, 03:43:54 pm
Re: Whats the standard thickness for a metal control panel?
« Reply #1 on: February 01, 2005, 11:53:36 am »
I think the last one I made was 16. Not 100% sure because I just picked up a scrap and used that. 16 or 18 should either work fine.

-S

Stingray you magnificent bastard!
This place is dead lately.  Stingray scare everyone off?