Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: ILMech BYOAC token adjustment  (Read 804 times)

0 Members and 1 Guest are viewing this topic.

rchadd

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1830
  • Last login:June 10, 2013, 06:14:06 am
  • Made in Cornwall
ILMech BYOAC token adjustment
« on: August 27, 2004, 06:03:47 pm »
help!

i've just tried to adjust my ILMech to take the BYOAC tokens as shown at http://www.miavio.com/HappILMech.htm

but i've taken slightly too much off! it now rejects every token  :'(

any suggestions on best way get it working?

i'm wondering if i can glue the L swing arm in place? but not sure if that would work

alternatively is it possible to adjust the ILmech to accept all coins?
Logged

rchadd

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1830
  • Last login:June 10, 2013, 06:14:06 am
  • Made in Cornwall
Re:ILMech BYOAC token adjustment
« Reply #1 on: August 27, 2004, 06:27:44 pm »
i've just noticed that if i tilt the mech back slightly the coins are accepted.

i am wondering if there is another adjustment i can make?
Logged

rchadd

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1830
  • Last login:June 10, 2013, 06:14:06 am
  • Made in Cornwall
Re:ILMech BYOAC token adjustment
« Reply #2 on: August 27, 2004, 07:27:43 pm »
i think i have fixed it ;)

i figured out that the tokens were being rejected at the magnet check. as i am not worried about this check i simply applied some tape over the reject slot to force the coin into the accept slot. its accepting all tokens now!
Logged
Pages: [1]
  
Go Up
« previous next »