Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Vortex spinner  (Read 899 times)

0 Members and 1 Guest are viewing this topic.

Scoobie

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 281
  • Last login:December 26, 2024, 12:53:48 am
Vortex spinner
« on: July 23, 2004, 01:02:19 am »
I'm ready to mount my vortex spinner in the cp and want to know what size to drill for the shaft?  The diagram on Oscar's site says "hole for shaft 5/8" to 1 1/8" diameter".

What does that mean?  What size should I use?

Oscar is on vacation until 8/2 and I'm planning to mount it this weekend.

Help on this is most appreciated!   :)
Logged

photorock

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 94
  • Last login:March 07, 2006, 08:37:03 am
  • Goofy Newfy!
Re:Vortex spinner
« Reply #1 on: July 23, 2004, 01:48:54 am »
          I drilled a 3/8" hole for mine, then rounded in out a little and it worked perfect. Make the hole a little bigger than the shaft and you will be fine. Just make sure the shaft doesn't bind up on the CP.
Logged
Pages: [1]
  
Go Up
« previous next »