Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up --- Bug Reports --- Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Cut control panel sides....  (Read 2354 times)

0 Members and 1 Guest are viewing this topic.

AtariYoungin

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 10
  • Last login:July 03, 2004, 02:56:58 am
  • I'm a llama!
Cut control panel sides....
« on: June 22, 2004, 07:51:12 am »
Why in the book does it state to shorten the cp side plates by 1/4" when using 5/8 for the CP top, now everything dosn't square up properly.

DennisInMN

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 65
  • Last login:August 22, 2018, 12:33:12 am
  • gunga, gunga ga lunga
Re:Cut control panel sides....
« Reply #1 on: July 04, 2004, 12:57:13 am »
Why in the book does it state to shorten the cp side plates by 1/4" when using 5/8 for the CP top, now everything dosn't square up properly.

The book states to shorten the CP sides if you intend to use 5/8-inch wood throughout your entire cabinet.  Because you lose 1/8-inch thickness on the CP front and back pieces the sides need to be shorten by 1/4-inch.