Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: .94" drillbit?  (Read 1171 times)

0 Members and 1 Guest are viewing this topic.

crashwg

  • Trade Count: (+10)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 3076
  • Last login:May 24, 2019, 11:01:05 am
.94" drillbit?
« on: May 06, 2004, 11:00:21 pm »
I just got some "Blue Momentary Contact Pushbuttons" from happ, http://www.happcontrols.com/pushbuttons/601200xx.htm, and I've noticed that the mounting hole they require is .94"...  I've never heard of a .94" drill bit, has anyone else?  I know that's pretty close to 1", but the lip of the bezel is only .06" larger leaving only .03" on each side!
Logged
If there's bees in the trap I'm catching em
By the thorax and abdomen
And sanding the stingers down to a rough quill
Then I dip em in ink, and I scribble a bit
But if it they wriggle then I tickle em until they hold still
Lemme say it again
In my land of pretend
I use bees as a mf'n pen

OSCAR

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1770
  • Last login:September 06, 2018, 11:31:53 pm
  • I think Bigfoot is blurry, that's the problem...
    • Oscar Controls
Re:.94" drillbit?
« Reply #1 on: May 06, 2004, 11:21:08 pm »
A 15/16" (.9375") should work just fine.  Or if you have access to metric drill bits, you can use a 24mm (.945").

Logged
Pages: [1]
  
Go Up
« previous next »