Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Got a foxAlien CNC, wonder if I could do a bar top?  (Read 1042 times)

0 Members and 1 Guest are viewing this topic.

Locke141

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1692
  • Last login:February 23, 2025, 06:44:01 pm
  • Never grow up.
Got a foxAlien CNC, wonder if I could do a bar top?
« on: June 12, 2023, 09:23:07 pm »
My restore of an old Nintendo cabinet into a multi 4way joysticks games is it good and pretty close to done. So starting to think about using the CNC, I have access to to do a few bartop.

Was thinking about the spray, painting, the body red, and using my vinyl cutter to make a white vinyl sticker for the sides. Does anyone know if there is an existent set of plans? The internal motherboard will be original.

In the picture below, I took from a design four full size and just took a photo of the section I'm looking for. Was thinking maybe extend the body to better support the Control panel.
« Last Edit: June 12, 2023, 09:52:24 pm by Locke141 »
Logged
Pages: [1]
  
Go Up
« previous next »