Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Grounding and i-pac  (Read 828 times)

0 Members and 1 Guest are viewing this topic.

Drakkorcia

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 58
  • Last login:September 02, 2024, 01:24:35 pm
  • I want to build my own arcade controls!
Grounding and i-pac
« on: February 06, 2021, 12:01:26 am »
I bought an i-pac with associated wiring and have the signal wires installed into the screw connectors. The only thing left is the ground daisy chain but it has the usual .187 female spade terminals throughout the entire chain; there is no tinned end on either end. Do I need to cut off one of the terminals at one end of the ground chain so the bare wire can be screwed into the i-pac? Or am I missing something?
Logged
Pages: [1]
  
Go Up
« previous next »