Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Help with Ipac 4 and Xinput mode  (Read 1177 times)

0 Members and 1 Guest are viewing this topic.

jarazix

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:December 04, 2023, 06:58:18 am
  • I want to build my own arcade controls!
Help with Ipac 4 and Xinput mode
« on: September 16, 2020, 08:44:44 pm »
Hello,

I just got my first IPAC and am having issues. I have it wired up and have confirmed button 3 and the start button are working. When I hold them for 10 seconds it does not switch to xinput mode. I tried all the other modes too and no dice. On 1.55 firmware with winpac2 software. Any advise? I tried a firmware update even though I was at current.

My second is just a question...will the ipac 4 work as 4 xinput? Or will I lose most of my controls? Is there a way to switch modes via command line? I've seen command line referenced, but no listing of commands. A lot of links I have seen go to now gone pages on ultimarc's site.


jarazix

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 3
  • Last login:December 04, 2023, 06:58:18 am
  • I want to build my own arcade controls!
Re: Help with Ipac 4 and Xinput mode
« Reply #1 on: September 18, 2020, 05:53:22 am »
keyboard2xinput has been my savior. Neat program.