Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: J-Pac Question  (Read 858 times)

0 Members and 1 Guest are viewing this topic.

barhoram

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 5
  • Last login:April 11, 2020, 06:17:46 pm
  • I want to build my own arcade controls!
J-Pac Question
« on: April 11, 2020, 05:35:05 pm »
I'm trying to connect a J-Pac to my cabinet's JAMMA connector and configure it.  My cabinet uses the Service Button which appears to come in on Pin "R".   However with the J-Pac software, that pin is not configuarable in the software.  It is only letting me configure up to the pin next to it (test/service).   

Any idea why I can't configure "Service"?
Logged

barhoram

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 5
  • Last login:April 11, 2020, 06:17:46 pm
  • I want to build my own arcade controls!
Re: J-Pac Question
« Reply #1 on: April 11, 2020, 05:53:41 pm »
Also--WinIpac reports Firmware Version 1.49

Logged
Pages: [1]
  
Go Up
« previous next »