Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: G07-CB0 Help Needed  (Read 1131 times)

0 Members and 1 Guest are viewing this topic.

Essen

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 1
  • Last login:February 11, 2020, 01:00:26 am
  • I want to build my own arcade controls!
G07-CB0 Help Needed
« on: February 10, 2020, 04:57:24 pm »
Hoping to get help with an old  Electrohome G07-CB0.  I just replaced, the flyback, caps, POTs and bottle caps. After I was all done it was just not bright enough and I had the brightness almost all the way up. I kept hearing something arcing  sporadically in the back as it sat and turned on.  Also, I think I turned the B+ too high and now it keeps blowing F901 (smaller fuse). Obviously I damaged something with the B+, but what would have been damaged? Getting very close to a LCD swap, but I would like to keep this older CRT if possible, but it is hard to justify spending anymore on this thing.  :dunno Appreciate any help/suggestions.