Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: J-Stick Ultimarc Rotary Upgrade Help  (Read 1002 times)

0 Members and 1 Guest are viewing this topic.

Gatt

  • Trade Count: (+3)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 225
  • Last login:February 04, 2020, 08:24:38 pm
J-Stick Ultimarc Rotary Upgrade Help
« on: January 12, 2020, 08:38:13 pm »
Hi all,

I started installing my J-Stick rotary upgrade today and ran in to a few problems.  The biggest one being - after I installed the new shaft and spacer washers there's too much "slop" in the joystick.  Feels like about a quarter inch of the shaft slides downwards when held flat and the actuator loses contact with the microswitches, almost as if the shaft is too long.

Has anyone installed a rotary kit on a J-Stick?  Were there any issues with the actuator hitting the switches?
Logged
Pages: [1]
  
Go Up
« previous next »