Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up --- Bug Reports --- Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


Author Topic: Video prob APB  (Read 426 times)

0 Members and 1 Guest are viewing this topic.


  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 26
  • Last login:September 14, 2020, 06:37:39 am
  • I want to build my own arcade controls!
Video prob APB
« on: December 10, 2019, 03:30:36 pm »
Hello. Having problems with replacement of Atari APB medium resolution monitor for computer vga lcd monitor, using a gsb 8200 converter. Tried every possible wire combo off both the 5 and 8 pin harness I could think of....  any help is much appreciated !!!


  • Trade Count: (+3)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 6547
  • Last login:September 15, 2020, 07:53:40 pm
  • I break stuff...then fix it...sometimes
Re: Video prob APB
« Reply #1 on: December 25, 2019, 01:03:01 am »
the GBS-8200 has been cloned so many times it's literally a copy of a copy of a copy of a copy of a copy.

that said, there is an under documented alternate sync where you pull the yellow wire and move it over one position in the harness plug. this can sometimes help weird boards sync properly.

other than that, it could be you just bought yourself an end of the clone line board. ideally, you'd want to try and source out older REV boards (like rev 3), it's more likely to work properly than the new super cloned boards with scab firmware in them.