Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: USB zero delay encoder question  (Read 942 times)

0 Members and 1 Guest are viewing this topic.

jasn040

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 1
  • Last login:May 30, 2019, 10:58:07 pm
  • I want to build my own arcade controls!
USB zero delay encoder question
« on: May 19, 2019, 05:44:16 pm »
Hello. Newbie here building my first control panel. The USB encoder came with a usb-b to usb cord but I don't have room to use it on the control panel I'm building, the usb-b sticks out too far. The (other) USB receptacle on the board is a 5-pin jst. My other boards only had 4 pins so those cables won't work. What is the 5th pin on this USB slot? There is a "G" and a "GND" (and d+, d-, vdd) What is the "G"? Does anyone know where I can buy the 5-pin jst xh to USB cable? The board I have is the "new" black version SJ@?? from Amazon.
Logged
Pages: [1]
  
Go Up
« previous next »