Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


  

Author Topic: T-Molding Installation  (Read 251 times)

0 Members and 1 Guest are viewing this topic.

tfity

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 6
  • I want to build my own arcade controls!
T-Molding Installation
« on: October 03, 2018, 07:48:05 pm »
On my control panel I may have off-centered the t-molding cut with the router slightly. Its like 1/8-inch off from center. I took me about an hour to make the main cuts and I really don't want to do it again. Can I just make the gap bigger and put some wood glue or Bondo in the cut to make the t-molding stick? Or am I screwed?

Appreciate the responses!

MartyKong

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 64
  • I want to build my own arcade controls!
Re: T-Molding Installation
« Reply #1 on: October 04, 2018, 12:33:47 pm »
No worries, Same thing happened to me. Simply tape off the off centered area and use bondo filler. Then reroute your Tmolding groove. After applying your Tmolding no one will be the wiser.

tfity

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 6
  • I want to build my own arcade controls!
Re: T-Molding Installation
« Reply #2 on: October 04, 2018, 07:50:10 pm »
Holy ---steaming pile of meadow muffin---. Didn't even think of that. Thanks!

  
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31