Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Electroluminescent Tape rather than LED T-molding  (Read 2628 times)

0 Members and 1 Guest are viewing this topic.

drewjbx

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 46
  • Last login:June 03, 2024, 02:36:17 pm
Electroluminescent Tape rather than LED T-molding
« on: October 20, 2016, 11:41:41 am »
has anyone tried installing this EL tape? LED t-molding doesnt look too appealing as light isnt spread evenly whatsoever.
With this tape no T-slots obviously and maybe using hot glue or another adhesive but not sure how well it can bend around 90's. Kinda strange it uses a 9-volt battery for power. They have a bunch on ebay.. but mostly only could find .55" width. Cheap as well..



http://www.ebay.com/itm/1-5M-Electroluminescent-Strip-9-V-Battery-Inverter-EL-Tape-Light-Lamp-9V-150CM-/141652541051?
« Last Edit: October 20, 2016, 11:43:17 am by drewjbx »
Logged
Pages: [1]
  
Go Up
« previous next »