IPAC not being detected by WinIPAC?

[hunterjwizzard]

Hi folks, not sure this is the best place to post, but here is my problem: I have the Ipac board and am building controls around it, but I cannot get the WinIPAC V2 software to read the board. I know its hooked and working because when I hit buttons I am getting characters, but even hooked directly to the PC(no USB hub/extension cable/etc) the software still does not detect a board.

Any help will be appreciated, thanks.

[brad808]

Is it an older board? Should you be using the original winipac and not version 2?

[hunterjwizzard]

Yep, that did the trick. I had thought I had an Ipac2, thanks!