Author Topic: IPac Ultimate 1P Down Not Working (Read 884 times)

Taflad · « **on:** April 01, 2016, 09:24:40 am »

Hi All,

Sorry to trouble you. I have the above, and for some reason, the 1P Down pin isnt working. After breaking out the trusty old MultiMeter, I tested the continuity from joystick to groung (was fine), replaced the joystick and cables anyway and tested again, still not working. Tested the pin to ground at the board and found i am getting 5v on every other pin except this one. I get 1.444v at 1P Down. Any ideas what could cause this? I have tried a different USB port (scraping the barrel I know, but im pulling my hair out)

Many thanks

wemr97dl · « **Reply #1 on:** April 01, 2016, 01:49:37 pm »

Just had the same problem with an Ipac4 with my Coin2 ,email Andy at Ultimarc

burn_654 · « **Reply #2 on:** April 01, 2016, 02:29:16 pm »

Maybe a bad pcb trace on that input? Try checking for continuity between the pin and the interface chip on the ipac/the next component it leads to.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: IPac Ultimate 1P Down Not Working (Read 884 times)

Taflad

IPac Ultimate 1P Down Not Working

wemr97dl

Re: IPac Ultimate 1P Down Not Working

burn_654

Re: IPac Ultimate 1P Down Not Working