Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Ultimarc Jpac help. Tried everything  (Read 1246 times)

0 Members and 1 Guest are viewing this topic.

mrcram

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 187
  • Last login:October 07, 2016, 05:47:03 am
  • OREGON STATE
Ultimarc Jpac help. Tried everything
« on: December 18, 2015, 02:05:33 am »
Setup an older Jpac board I bought in 14.  I am only getting a quick LED flash and then nothing.  I have tried everything.  Legacy usb off and on, winipac software drivers, different usb slots and nothing.  I have tested on 2 computers and same results.  The computers can see it is there and say that it needs a driver.  Any ideas?
Logged

menace

  • Trade Count: (+5)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 2565
  • Last login:November 08, 2024, 01:49:35 pm
Re: Ultimarc Jpac help. Tried everything
« Reply #1 on: December 19, 2015, 07:39:45 am »
email andy directly.  I had a setup question with my minipac and he got pack to me in less than 24 hrs with an answer--not bad consider there is a 6 hr time difference between us.  I had a jpac that died and it was the little chip on the board--he just sent me a new one and I was good to go--that was years ago though..
Logged
its better to not post and be thought a fool, then to whip out your keyboard and remove all doubt...
Pages: [1]
  
Go Up
« previous next »