Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Trackball Mounting Plate Question  (Read 840 times)

0 Members and 1 Guest are viewing this topic.

Metimbo

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 65
  • Last login:June 15, 2010, 02:52:32 pm
  • A stretched mind will never be the same again.
    • Metimbo's Website
Trackball Mounting Plate Question
« on: January 06, 2004, 02:09:56 pm »
Ok, got my mounting plate in from Happs.  I will be routing the CP so it sits flush, then putting vinyl on top, then putting 1/8" Lexan on top of that.

Question is, how did you cut the 3" hole in the Lexan?  I want it to be perfect and would like to use the Laminate Trimming Router Bit, but I don't think it's going to work.
3" Hole Saws are like $20 and it doesn't look like they would give me a good finish on the Lexan.

Suggestions?
~Tim
Logged
Pages: [1]
  
Go Up
« previous next »