Where to get a minimus AVR with the KADE 4-Axis firmware?

[dgame]

Where to get a minimus AVR with the KADE 4-Axis firmware?

I can also pre-pay (PayPal) if someone experienced with the KADE like PL1 or degenatrons is willing to make one for me. I don't need header pins and terminals as I can solder directly to the board.

I am putting together a Warlords Cocktail emulator using an old tablet PC.
Currently using the A-Pac which works great with the four Paddles/300k Potentiometers and buttons.
However, I want to embedded the controller interface into the dock holding the tablet and it seems like the minimus KADE would be the smallest I can get for a 4-Axis / at least 4 buttons interface.

Please advise.

Thanks!!!

[PL1]

Where to get a minimus AVR with the KADE 4-Axis firmware?

The minimus uses an atmega32u2 = no analog inputs.

Check out the KADESTICK (atmega32u4) thread here.

It has full directions on ordering the correct board/options from MattairTech, the 4-axis firmware here, and loading the firmware using FLIP here.


Scott

[dgame]

Thanks for the info Scott.

Upon further review I think if I desolder and remove the header pins and terminals from the A-Pac it would fit in my  application.

 I may go the KADE route on a future project. Thanks!