Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Restrictor Plate ?  (Read 803 times)

0 Members and 1 Guest are viewing this topic.

Metimbo

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 65
  • Last login:June 15, 2010, 02:52:32 pm
  • A stretched mind will never be the same again.
    • Metimbo's Website
Restrictor Plate ?
« on: December 31, 2003, 09:15:28 am »
Ok, I am building a 4player CP.  I have 2 Happs Supers for players 1 and 2.  Then, I have Happs Mech Rotary's for 3 and 4 players.
I also bought a restrictor plate from Oscar Controls.  Well, I cut my CP holes already and I just noticed that if I put the restrictor plates on player 1 or 2, that it is too big and cuts into my buttons   :(
Has anyone tried to use them with the Rotary Mechs?  Does anyone see any inherent problems with it?
Thanks in advance,
~Tim