Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Question About Coin Door & Credit Button Wiring  (Read 1210 times)

0 Members and 1 Guest are viewing this topic.

Santo8742

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 68
  • Last login:September 11, 2015, 06:48:39 pm
Question About Coin Door & Credit Button Wiring
« on: May 10, 2015, 09:40:12 am »
I was reading that the wiring for a coin door microswitches should be set to the NC position as opposed to normal buttons and joysticks. Is this correct? Also if I'm wiring free credit buttons to the same input as the coin door, should those buttons be set to the NC position as well?
Logged

WakiMiko

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 317
  • Last login:January 04, 2019, 03:17:46 pm
Re: Question About Coin Door & Credit Button Wiring
« Reply #1 on: May 10, 2015, 09:51:40 am »
Nope, you wire them to NO (normally open) like every other switch. The same goes for the credit button, which you should wire in parallel.
Logged

Santo8742

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 68
  • Last login:September 11, 2015, 06:48:39 pm
Re: Question About Coin Door & Credit Button Wiring
« Reply #2 on: May 10, 2015, 10:02:55 am »
Quote from: WakiMiko on May 10, 2015, 09:51:40 am
Nope, you wire them to NO (normally open) like every other switch. The same goes for the credit button, which you should wire in parallel.

Thanks. That makes sense. I did notice that the NO position is the pin furthest from the common as opposed to the switches on my buttons which have NO as the pin closest to the common though. So just a tip to any other newbie, make sure you read the switch because aren't always set up the same.
Logged
Pages: [1]
  
Go Up
« previous next »