Author Topic: Wiring Solenoid for arcade gun (Read 864 times)

tylerwerrin · « **on:** December 30, 2014, 09:22:16 pm »

Hi guys,

I purchased a few solenoids from the internet and found a great product that is only 40 cents and provides a nice amount of "kick". I think it is the same size as Andy's solenoid, although I am not sure. Right now I am planning on wiring it up but I am not sure how to make the trigger & kick of the solenoid "momentary". I was planning on tapping into the trigger switch, but if I held the trigger down it would heat up the solenoid fairly quickly (i'm using a 36v 10amp power supply on a 12v solenoid).

Has anyone one accomplished this? Are there any good write ups on this site I could use?

Thanks!

Tyler

TimeCrisis · « **Reply #1 on:** December 31, 2014, 04:53:05 am »

maybe these might help

https://forum.arcadecontrols.com/index.php?topic=119610.160

'Just followed the recoil kit schematics and skipped his solenoid and his gun halvs which you buy seperately'

http://www.snapthepix.com/NAMCO-GUN-AimTrak-MOD-Photos-by-gstav80


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Wiring Solenoid for arcade gun (Read 864 times)

tylerwerrin

Wiring Solenoid for arcade gun

TimeCrisis

Re: Wiring Solenoid for arcade gun