Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: wg 27d9200  (Read 991 times)

0 Members and 1 Guest are viewing this topic.

harbngr

  • Trade Count: (0)
  • Newbie
  • *
  • Offline Offline
  • Posts: 1
  • Last login:February 13, 2015, 06:58:37 pm
  • I want to build my own arcade controls!
wg 27d9200
« on: June 21, 2014, 10:40:24 am »
Just looking for some advice and guidance.

I got a wg 27d9200, was told the flyback was bad. So I replaced that and did a cap kit on it. Now when I power it with/without a signal I get a blank screen. if I turn up the brightness I get a white screen.

I do not get an OSD, or even a no signal display when I do not have anything plugged in.

Thanks in advance

Jerry
Logged

grantspain

  • I personally prefer "bog trotter"
  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 6177
  • Last login:June 21, 2025, 12:51:59 pm
Re: wg 27d9200
« Reply #1 on: June 21, 2014, 10:54:25 am »
it could be ic201 on the neck card plus you will need to check +5v and +12v
check the video interface pcb and connections
it also possible ic101 is faulty
Logged
Pages: [1]
  
Go Up
« previous next »