Author Topic: Daphne & ArcadeVGA (Read 1037 times)

Zeeman · « **on:** November 29, 2003, 01:56:58 pm »

I have an 15hz arcade monitor and the ArcadeVGA card. When I start Dragon's Lair using Daphne only the top half of the video is being shown. I'm guessing this is because the video was captured as non-interlaced and is 2x the height I need. Does Daphne have command switch or something to correct this? Or do I need to re-encode all the video to get it to work right?

Thanks!

Minwah · « **Reply #1 on:** November 29, 2003, 05:07:38 pm »

I'm not sure 100%, but I seem to remember Daphne has a 'video hardware acceleration' mode or similar. Try toggling it to see if it makes a difference...

Also, check what resolution Daphne is running in, I'd suggest setting it to 640x480

dreamfreak · « **Reply #2 on:** December 03, 2003, 03:11:32 am »

dreamfreak · « **Reply #3 on:** December 03, 2003, 01:12:11 pm »

hi,
it was the button "disable hardware acceleration (MPEG only)"
now it works fine

thx again a lot to minwah


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Daphne & ArcadeVGA (Read 1037 times)

Zeeman

Daphne & ArcadeVGA

Minwah

Re:Daphne & ArcadeVGA

dreamfreak

Re:Daphne & ArcadeVGA

dreamfreak

Re:Daphne & ArcadeVGA