Rowe Error codes reset

[Z0MBIE]

What's the procedure to reset the error codes in a Rowe cd-100h jukebox?

[ed12]

clering error/warnings from memory

1 enter service mode
2 press 6
3 press 1
4 press popular it will blink at u

note
if already  in service mode ,or u want to start over,hold reset switch and
repeately press popular until display shows service mode,then start at step 2

that is right out of the trouble shooting guide

ed

[Z0MBIE]

Thanks! but keeps coming back to error 53

[ed12]

error code 53

outer cam switch always open
meaasage means
mechanism control thinks a switch is not working

proable cause
1 a switch
2 a short or open
3 the mechanism control

ed

[Z0MBIE]

ya, I tested it with a continuity tester and is working so for s&g i disconnected it cleared codes again and now code 50 comes up first.

[ed12]

error code
50,51,52,53

50 inner cam switch always colsed
51 inner cam switch always open
52 outter cam switch always colsed
53 outter cam switch always open

ed

[Z0MBIE]

hmmm that plastic cam is holding the inner switch closed.

[ed12]

wind the cam back
so as to realse the switch
see if the control boards makes it enguage again ?
if so u are looking at the error to posts down
mech control board

ed

[Z0MBIE]

I'm unable to move the cam in either direction with my fingers.

[ed12]

power unit down and try
if not remove mech from machine
take it apart to point  where u can do it
soory bud but the errors codes do not lie

ed

[Z0MBIE]

Tomorrow's project will let you know. Thanks!

[Z0MBIE]

Update- it turns out the shaft on top was seized so I had to take that out and clean it up and lube and put back in. So now it will put on a cd and play but you can't hear it really unless you put your head right to the subs. I can hear the amp is on and hissing when I crank the volume up. I even tried putting the whole thing into another jukebox but get the same. Could a bad laser cause this?