Author Topic: Neotec NT 3602 chassis (Read 2211 times)

deep-c · « **on:** September 23, 2013, 12:19:02 pm »

I have a Hydro Thunder 39" cabinet with a 36" monitor (Neotec NT-3602 chassis). The HOT keeps blowing upon power-up; sent board out for repair after repairing myself-same issue-HOT blows and all capacitors are good. What besides a bad neck or tube could keep doing this? The power supply seems to be alright but what should the voltage/amperage be going from the Power supply to the monitor chassis? I have been dealing with this for over a year and am losing the battle

. Any suggestions out there? I have been actively seeking a replacement monitor however 36" VGAs or Tri-modes are hard to come by.

Thanks in advance for any help!

ed12 · « **Reply #1 on:** September 23, 2013, 02:57:49 pm »

your yoke

and that is not a joke

the yoke is out of freq,thus driving the horz sweep out of freq
or your flyback is shot
good luck on the yoke..they are made by a of shore co. long gone

ed


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Neotec NT 3602 chassis (Read 2211 times)

deep-c

Neotec NT 3602 chassis

ed12

Re: Neotec NT 3602 chassis