Author Topic: Couple questions on the PacLED64 (Read 1321 times)

fatsgt · « **on:** September 19, 2013, 03:53:18 pm »

I recently bought a PacLED64 with both Ultimarc RGB buttons and single color buttons and I have a couple questions.

1. Does this need to be connected to both a USB port and the computer via the Molex connector or just one of the two? I'm assuming both. If so,

2. Is anyone using any options to connect power to the unit via an external supply? I'm assuming if you have one with with correct voltage it would be possible.

3. I didn't order the Extension Harness Pack to connect the wires to the board but it looks like I'm going to go back an order them. How do those connect to the PadLED64 Board? Do they have some sort of hollow end on the wire?

Thanks folks!

Nephasth · « **Reply #1 on:** September 19, 2013, 08:12:55 pm »

1 - Yes
2 - Yes
3 - Yes


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Couple questions on the PacLED64 (Read 1321 times)

fatsgt

Couple questions on the PacLED64

Nephasth

Re: Couple questions on the PacLED64