Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: U-HID G Calibration?  (Read 761 times)

0 Members and 1 Guest are viewing this topic.

GeoMan

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 183
  • Last login:Yesterday at 11:39:49 am
U-HID G Calibration?
« on: July 23, 2013, 06:29:13 pm »
No matter how many times i tried calibrating and changing sensitivity and offset values, i am still unable to properly calibrate my U-HID G to use it's nudge functions.

I was able to center the U-HID G cursor by changing the settings in U-Config, but it still jitters slightly so i get random nudging from time to time. It looks like there is no deadzone.

Any one had better luck with U-HID G and if so how?


GeoMan

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 183
  • Last login:Yesterday at 11:39:49 am
Re: U-HID G Calibration?
« Reply #1 on: July 26, 2013, 02:56:54 pm »
After a lot of trial and error and a firmware update, i was able to calibrate the U-HID G!

Sensitivity is set at 4 (the only value that allowed a centered cursor). Nudge works on both VP and FP. I only need to adjust some values in VP to make Tilt less sensitive.