First off there are some Really talented cabinet builders here. I wish I had room for cabinets but I dont, one day. I would love a room full of them because I grew up in the golden age of arcades. So I have to make controller's.
I was not sure where my post should fall, since it is complete now & falls under a couple of things.
I already have a dual stick setup. I was missing a dedicated 4way joystick & was needing one bad. So I picked up an original Pacman joystick.

This felt wrong making a controller out of it, to me. One day it will go into a cab. It was so rusted & broke, I could not let it be forgotten or destroyed over time. To me this was the best 4way joystick ever made & designed

So here it is how I got it. The grommet is busted & the joy is rusted.


Starting the rehab.

This is as much as I could get it cleaned.

New centering grommet put on. The other plate cleaned up


Now I wanted to keep the joystick in metal, since it is a short shaft.

The original leaf switches were shot on this. I had to get replacement size leaf switches for it. I also used the classx leaf switches from GGG , for the buttons.

So here it is put together

I hand cut the pacman logo name out of a purple chrome vinyl.

Made PacMan on the dust washer.

Then I made a stencil type for the side ghost's. One side is red, the other side pink. It is hard to tell from the pic but the ghost's are metallic. I did it this way, so it would let the metal thru the color

Plus who does not like shiny things

hehehehehe

So that is what I came up with & built. Hope ya like it. Thanks for looking