Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: ESC to quit hyperspin but not hyperpin vp ?  (Read 1110 times)

0 Members and 1 Guest are viewing this topic.

Connorsdad

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 268
  • Last login:May 18, 2024, 04:28:42 pm
  • I want to build my own arcade controls!
ESC to quit hyperspin but not hyperpin vp ?
« on: June 10, 2013, 02:46:35 pm »
I'm currently using E or ENTER to make a selection in hyperspin and ESCAPE to quit/go back which will be mapped to P1 button + P2 button when I finish my cab control panel, my problem is I have hyperpin launching from hyperspin which still uses ENTER to make a selection which is fine but the ESCAPE key (Potential P1+P2) brings up a quit to editor menu in visual pinball. To quit vp I have to press E and select quit or hold down E for 3 seconds. This seems counter intuitive, how do you folks have this setup ? also, what button\s on your CP do you have mapped to ENTER/E ?