Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Trim bezel for 2 1/4 Trackball  (Read 978 times)

0 Members and 1 Guest are viewing this topic.

GeoMan

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 183
  • Last login:Yesterday at 12:56:19 pm
Trim bezel for 2 1/4 Trackball
« on: June 10, 2013, 05:34:26 am »
I will mount a 2 1/4 Trackball and unfortunately i can't use a mounting plate. To make it look good i think that a trim bezel (like the one for the U-Trak) would be a nice solution.

It doesn't need to be of the exact trackball opening size - i'll just cut a larger hole on my plexi + metal plate if it is slightly wider. I was thinking to use the trim bezel from U-Trak but it is is too wide!

Any ideas? Where can i get a similar with the U-Trak trim bezel at about 6-7cm? Or use something else as a trim bezel?

Logged
Pages: [1]
  
Go Up
« previous next »