Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Securing acrylic to the control panel  (Read 1037 times)

0 Members and 1 Guest are viewing this topic.

CoryBee

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 2093
  • Last login:May 18, 2024, 07:28:48 am
  • Bopity Boopy
Securing acrylic to the control panel
« on: April 13, 2013, 10:28:39 am »
Are the buttons enough? I put low profile screws on the corners of my 2-Player bartop builds for good measure. But is that necessary?

I ask this because I am gearing up to finish the 4-player control panel and don't want 8 screws or something on top of it.....
Logged

Nephasth

  • Guest
  • Trade Count: (0)
Re: Securing acrylic to the control panel
« Reply #1 on: April 13, 2013, 11:14:48 am »
Buttons and t-molding are enough.
Logged

CoryBee

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 2093
  • Last login:May 18, 2024, 07:28:48 am
  • Bopity Boopy
Re: Securing acrylic to the control panel
« Reply #2 on: April 13, 2013, 11:31:20 am »
Quote from: Nephasth on April 13, 2013, 11:14:48 am
Buttons and t-molding are enough.

Thanks boss, just anal about getting dust in-between the acrylic and art.
Logged

shponglefan

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1600
  • Last login:December 15, 2022, 07:22:35 am
  • Correct horse battery staple
Re: Securing acrylic to the control panel
« Reply #3 on: April 13, 2013, 12:28:29 pm »
Unless the T-Molding is loose or the acrylic isn't flush with the pnael edges, dust should not be an issue.
Logged
Pages: [1]
  
Go Up
« previous next »