Seeking help from someone with a Centipede upright.

[Justin]

Hi!  I'm in the process of creating a custom Centipede bezel for my Centipede upright cabinet.  I am looking for someone with a Centipede upright that is willing to take a few close up pictures of the bezel so I get some really detailed shots of the artwork.

You can see my progrss so far here:
http://www.arcadecontrols.org/yabbse/index.php?board=13;action=display;threadid=12386

I need closeup pictures of the bottom, top, and sides.  Anyone willing to help?

Thanks!
-J

[Justin]

These are the only parts I need to finish the bezel (outlined in red below).  Everything else has been traced!   I guess I can figure this out, but I don't have a single closup of the borders of the bezel, and would like to make it as accurate as possible.

If you have a Centipede bezel, please take high quality closeups of these 4 areas and post them.   This would help me tremendously.

Thanks!

[Larry Smith]

Great work so far, I will send you the pictures tommorow.
Any intrest in doing the same for control panel artwork?

[Justin]

Great work so far, I will send you the pictures tommorow.
Any intrest in doing the same for control panel artwork?

Thanks!  I'm already done with the bezel, just waiting for you to send me the spots outlined above.

My Centipede cabinet has a custom control panel, which is totall black.  I plan on keeping it that way, and don't really need a CPO.
That should be a piece of cake to trace though. (compared to the Bezel, anyways)

When you take the pictures of the bezel, please try taking them as large as possible.  This way I can trace accurately.  Send me a PM when you're ready, and I'll give you my email address so you can send them to me directly.

Thanks a ton for this!!!