Cocktail cabinet with trackball and spinner control panels???

[cmoses]

I just recently acquired a cocktail cabinet that I will be turning into a MAME cabinet. I thought I had seen a cocktail cabinet recently that had 1 joystick, 3 buttons and a trackball one on side and 1 joystick, 3 buttons and a spinner on the other side. I did a bunch of searching but have not been able to find it. Does anyone know if the cocktail cabinet I am referring to?

[PL1]

Sounds like Millercentral's 3-sided cocktail.

Panel pics in this thread.


Scott

[cmoses]

No that was not it. It was only 2 sided. As I recall one side had red joystick and buttons. The other side was blue. Joysticks on left, buttons in middle, trackball or spinner on the right.

[wxforecaster]

I'd be curious to see this as well. Looking at my Midway cocktail at least, I just don't see a way to make it fit given the real-estate taken up by a joystick and trackball. I figure someday I'll own a millipede/centipede and marble madness and I'll be good

[cmoses]

So I finally found it. It wasn't a project but a cocktail table by Monster Arcade. You can see it here.



Still like the idea. I wonder if it could be done on a Midway/Namco cocktail cabinet. I have 11" wide control panels. I bet you could get a 8 way joystick 3 buttons and a 2 1/4 in trackball on there.
Then the same except a spinner instead if the trackball on the other side.

Anyone out there done this?