Author Topic: Slikstick Tornado not working (Read 1125 times)

Squizzy · « **on:** July 24, 2012, 03:18:29 am »

Hello
I my Tornado Spinner is not working,
I would guess it has had no more than 5 hours of usage. Very low use.

I have looked at the PC board, could not see anything with a cold solder joint,
Tried a standard mouse in the pc, where that works fine.

Now is there some where I can just buy the PCB Board?
As I guess its either the CY7C63723-PC Chip on t he board, or the 2 Optos.

The problem I had since day one, was that I would have to start the pc, Plug and unplug, spin while booting etc to get it to work.
So I think it might have been flawed since purchase.

I should have asked way back then.

Anyone with ideas?

Gray_Area · « **Reply #1 on:** July 29, 2012, 02:32:54 am »

Quote from: Squizzy on July 24, 2012, 03:18:29 am

So I think it might have been flawed since purchase. I should have asked way back then.

Yeah. Way back.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Slikstick Tornado not working (Read 1125 times)

Squizzy

Slikstick Tornado not working

Gray_Area

Re: Slikstick Tornado not working