Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: T-Molding replacement for a MAS Systems stick  (Read 1212 times)

0 Members and 1 Guest are viewing this topic.

JHFerry

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 20
  • Last login:December 30, 2011, 01:11:43 pm
T-Molding replacement for a MAS Systems stick
« on: December 07, 2011, 10:36:37 am »
I have 2 old MAS Systems sticks that I want to recondition a bit.  The T-molding on them could really used to be replaced.  Can I just buy new T-molding and bang it into the existing slot cut for it with a mallet or something?  There are spots now where its starting to "pop" out in some places from age.
Logged

BobA

  • Trade Count: (+14)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 5943
  • Last login:July 11, 2018, 09:52:14 pm
  • What Me Worry?
Re: T-Molding replacement for a MAS Systems stick
« Reply #1 on: December 07, 2011, 10:26:39 pm »
Measure your molding.   It should be 3/4 or 5/8 inch and take off the old and bang the new into the slot with a rubber or wood mallet.   Relieve the corners with some snips and the new molding should fit quite tightly.  It the slot has been damaged or is very worn hot glue does wonders.

Logged
Pages: [1]
  
Go Up
« previous next »