Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Cutting Artwork  (Read 1218 times)

0 Members and 1 Guest are viewing this topic.

Necro

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1031
  • Last login:November 29, 2022, 08:22:22 pm
  • Building a 'Classic' MAME Cab
Cutting Artwork
« on: May 23, 2011, 07:58:10 pm »
Anyone need to 'cut/trim' the edge of CPO artwork?  It's looking like I'm going to have to do mine myself (the cutting) and I'm trying to figure out the best way to do it and make sure it's accurate.
Logged

javeryh

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 7968
  • Last login:Today at 10:07:20 am
Re: Cutting Artwork
« Reply #1 on: May 24, 2011, 08:10:00 am »
Use painter's tape to keep it in position.  Flip the CPO upside down and use a utility knife to trim away the excess/overhang. 
Logged

scream1973

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 139
  • Last login:July 25, 2014, 10:28:46 am
Re: Cutting Artwork
« Reply #2 on: May 24, 2011, 09:14:20 am »
Assuming its sticky  put it in place on the cpo and then run a sharp knife (utility , xacto etc) along the edge and cut.
I did the smae for the holes with great results.
Logged

Necro

  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1031
  • Last login:November 29, 2022, 08:22:22 pm
  • Building a 'Classic' MAME Cab
Re: Cutting Artwork
« Reply #3 on: May 24, 2011, 02:23:56 pm »
It's not - actually needs to be cut pre-application and I need it to be perfectly straight.  I'm leaning towards rotary cutter and straightedge.
Logged

fallacy

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 992
  • Last login:March 11, 2025, 01:20:39 am
Re: Cutting Artwork
« Reply #4 on: May 26, 2011, 03:51:31 am »
Thick straight edge with clamps on both ends. – razor blade
Logged
Pages: [1]
  
Go Up
« previous next »