Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: WTB / WTT: Happ P2 Button with vertically aligned bracket [US/CA/Los Angeles]  (Read 855 times)

0 Members and 1 Guest are viewing this topic.

Pixelhugger

  • Trade Count: (+8)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 1865
  • Last login:March 24, 2025, 05:45:13 pm
WTB / WTT: Happ P2 Button with vertically aligned bracket [US/CA/Los Angeles]
« on: May 13, 2011, 06:10:19 pm »
I need a HAPP 2 player button with a switch bracket/plunger aligned vertically like the 1P button seen in the photo below. (I need the bracket to be aligned with the player graphic when the button is installed. Alignment is determined by the plunger on the player graphic)

Anybody have one to sell/trade? I have some NOS WICO 3.5" Ball Top shafts in Red, Orange, Purple, Yellow, or Green  ;D

« Last Edit: May 13, 2011, 06:20:10 pm by Pixelhugger »
Logged
Project mega thread HERE
Pages: [1]
  
Go Up
« previous next »