Need pic/explination

[wonderalex]

Hi there,

I'm stuck on a couple of details and I'm hoping someone can give me a hand. I've been looking around the forums at Robotron/William restorations & conversions looking for an answer for 2 things without much luck:

1. I need a picture (or explanation) of how the bezel glass is installed - with dimensions of the glass if possible. I assume the glass slots into the groove right below the CP but I'm unsure how to secure it. I think there's a piece that goes between the CP and the glass (or plexi in my case).

2. This is more for people who've done conversions:  The CP clamps on either side are in the way of the flipper buttons needed for pinball - so is there an alternative method of securing the CP?

Thanks in advance.

Be seeing you,

WonderAlex