Author Topic: Spinner/joystick question (Read 1954 times)

ZERO · « **on:** February 10, 2011, 07:43:02 pm »

I may have ordered the wrong spiner, but I'm not sure. I ordered a quad controller from north coast custom I then ordered my spiner from Ultimate arcade, it was there only one so I was thinning they where all the same. But when I tried to install it the pin does not come all the way up. Do I need to drill it? Did I buy the wrong spiner? If you need more info let me know.

And about joysticks I have 4 old joysticks from an arcade, I could use them but I would have to drill the 4 bolts out. Or is there joysticks that don't require me to dill?

BobA · « **Reply #1 on:** February 10, 2011, 08:13:31 pm »

Don't know which spinner you ordered as the site for ultimate arcade did not come up. This is the spinner that is referenced by NC Custom.

Tornado

ZERO · « **Reply #2 on:** February 11, 2011, 03:18:36 am »

http://www.ultimarc.com/JShopServer/section.php?xSec=10

looks like i got the wrong one thanks


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Spinner/joystick question (Read 1954 times)

ZERO

Spinner/joystick question

BobA

Re: Spinner/joystick question

ZERO

Re: Spinner/joystick question