Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Plexiglass Options  (Read 1086 times)

0 Members and 1 Guest are viewing this topic.

DashRendar

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 488
  • Last login:November 06, 2015, 05:46:52 pm
  • "Don't get your servos in a twist pal."
Plexiglass Options
« on: March 30, 2010, 10:51:08 am »
So was I just browsing over at Mamemarquees.com and noticed this on their control panel overlays-

Quote
Our Control Panel overlays are covered with Polycarbinate laminate (also used for bullet proof glass!) which offers a very tough, scratch resistant and textured surfaces. This will last a long time and take a lot of abuse. Don't settle for vinyl laminate!

I've never heard of this stuff before.  I already have a custom-cut plexi cover for my control panel (which I suspect is vinyl), but this sounds like an interesting option for future projects.

Has anyone here used this?  Is it difficult to cut/drill?
Logged
WANTED: Somebody to go back in time with me. This is not a joke. P.O. Box 322, Oakview, CA 93022. You'll get paid after we get back. Must bring your own weapons. Safety not guaranteed. I have only done this once before.

DolansCadillac

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 53
  • Last login:April 07, 2021, 05:51:14 pm
  • Can't buy a bucket
Re: Plexiglass Options
« Reply #1 on: March 30, 2010, 11:56:57 am »
Quote from: DashRendar on March 30, 2010, 10:51:08 am
Has anyone here used this?  Is it difficult to cut/drill?

Nah, not at all. I bought an overlay from MMs, a sharp knife will cut out any holes easily. It can definitely take a beating too.
Logged
Pages: [1]
  
Go Up
« previous next »