So I have these bartop machines that I'm converting into 48-in-1's.
I noticed on the chassis that it has two switches.
They read :
POSI-V-NEGA & POSI-H-NEGA
So
obviously (BOY WAS I WRONG) they are for vertical & horizontal orientation.
I would assume for my needs I would put the V switch to "POSI" & the H switch to "NEGA."
Would the top of the monitor be the part with the suction cup from the fly back ?

I also noticed on the chassis a section for the yoke, where one says H & one V.
Obviously depending on the orientation depends on which you use.*** EDIT *** Do you connect the set with the letter that would match your monitor orientation ?
V - vertical, H - horizontal
I've included pictures, but I cant tell which is for which.
I labeled it in photoshop, I think I have it correct.

