Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Two 2:3 Scale Minicabs  (Read 1526 times)

0 Members and 1 Guest are viewing this topic.

Boingo

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 42
  • Last login:March 14, 2014, 09:13:41 pm
Two 2:3 Scale Minicabs
« on: December 26, 2009, 10:56:25 pm »
 just finished building two 2:3 scale cabinets for my nieces.

The cabinetry is all done, but the project is not quite finished.  The cabinets are supposed to use Jakks Pacific Plug and Playi games in them, but when I removed the cases from the games (so they will fit inside the control panel) I have a problem with the flimsy wires in them tearing away from the boards.  Physically, the cabinets are done.  Electronically, I still have work to do.

Anyway, I have just completed a short video about them.



Enjoy.

Don't forget to rate and comment.

BobA

  • Trade Count: (+14)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 5943
  • Last login:July 11, 2018, 09:52:14 pm
  • What Me Worry?
Re: Two 2:3 Scale Minicabs
« Reply #1 on: December 26, 2009, 11:58:33 pm »
Good work so far.   A little patient soldering will get you where you want to go.   Use a low wattage soldering iron and try not to lift the traces on the boards.