I used the B&W Vector Monitor Guide to do some testing...
According to the guide, X-OUT should measure 6.68 at the molex connector... it measures 6.3 and fluctuates to 6.4 from time to time.
Y-OUT should measure 6.69 at the molex connector... it measures 3.6 to 3.7...
Z-OUT should measure 6.7 at the molex connector... strangely, I can not get ANY reading for Z-OUT... zero. Is that right? Would an image appear onscreen if it's getting zero voltage at Z?
Anyway.... to continue....
30VAC measures 29 and change...
Pin 11 is 6.3VAC that is supposed to measure 9.7 according to the guide... it measures JACK... nothing...
What's that tell you smart guys?