Author Topic: Making a new top for simpsons control panel questions (Read 2462 times)

codenamed · « **on:** August 01, 2009, 06:50:58 pm »

Hello everyone its been awhile... anways I want to make a new top for my control panel as Im adding multigame board and I dont want to ruin the simpsons cp by drilling holes through it. My question is what type of router bit do I need if I just take the cp top off lay it over a some mdf and just follow the outline to make an exact duplicate. Sorry in advance if my question is confusing and or stupid.

miles2912 · « **Reply #1 on:** August 02, 2009, 04:23:46 pm »

Patter cutting bit.

http://www.woodcraft.com/Family/2001862/WoodRiver-Anti-Kickback-Pattern-Cutting-Router-Bits.aspx

I just grabbed the fist link as an example. Basically you just clamp the 2 pieces of wood together and go from there.

codenamed · « **Reply #2 on:** August 02, 2009, 10:05:51 pm »

Now what tool do I need to cut the back of the panel at an angle so it butts up tight with the cab. Working with roughly 130 dollars.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Making a new top for simpsons control panel questions (Read 2462 times)

codenamed

Making a new top for simpsons control panel questions

miles2912

Re: Making a new top for simpsons control panel questions

codenamed

Re: Making a new top for simpsons control panel questions