Author Topic: How much t molding? (Read 2871 times)

zaktallica · « **on:** February 25, 2009, 03:46:10 pm »

I have a mortal kombat 2 midway cab and was wondering if 20 feet of t molding would be enough? Im not putting any on the back.. Thanks

shardian · « **Reply #1 on:** February 25, 2009, 03:54:50 pm »

Measure it up with a tape measure. Should only take a minute or two.

Off the top of my head, I would say that 20' is not close to enough due to the extra edges on that cab.

zaktallica · « **Reply #2 on:** February 25, 2009, 03:58:28 pm »

Ya im not home and was going to buy some now and was just wondering if someone knew.

Malenko · « **Reply #3 on:** February 26, 2009, 08:18:05 am »

its not if you're replacing all the Tmolding

cmoses · « **Reply #4 on:** February 26, 2009, 09:26:42 am »

I am in the same boat, getting ready to buy some T-Molding for my Mortal Kombat II cabinet that I am redoing. I measured all the edges including the top of the control panel and it comes close to 28 feet being conservative. So you will probably need to order 30 feet. That is what I am planning to get from T-Molding.com.

FrizzleFried · « **Reply #5 on:** February 26, 2009, 10:40:05 am »

Unfortunately T-Molding.com sells in 20 foot increments I do believe...

shardian · « **Reply #6 on:** February 26, 2009, 03:43:58 pm »

Groovygamegear.com sells tmolding by the foot. I've gotten blue from there and it is identical to T-molding.com samples I had.

Malenko · « **Reply #7 on:** February 26, 2009, 04:16:07 pm »

you need about 30 feet for 90's Midway 2player cabs slightly more for the 4 player CP it cant hurt to order 40 feets and keep some as a spare especially considering the cost


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: How much t molding? (Read 2871 times)

zaktallica

How much t molding?

shardian

Re: How much t molding?

zaktallica

Re: How much t molding?

Malenko

Re: How much t molding?

cmoses

Re: How much t molding?

FrizzleFried

Re: How much t molding?

shardian

Re: How much t molding?

Malenko

Re: How much t molding?