LED PUSHBUTTON HELP !!!

[JohnnyD]

Hello fellow members,



I am building a Naomi 1 based Marvel VS Capcom 2 cabinet. I plan to use these LED pushbuttons I purchased off ultimarc.com. I was wondering on how I can run them on my set up? If I was going the Mame route, I would use the LED Wiz but for the Naomi, I'm quite unsure.


Thanks for reading!

[Franco B]

What do you want to do with them, just light them? If so you just need to provide them with a 12v source. I dont know if there is a 12v point you can tap into from your system. If not you could just scavenge a PC PSU and take the power from one of the 12v yellow molex's.

[Ginsu Victim]

Exactly what Franco said.

Have you seen my review of Ultralux pushbuttons from yesterday?

http://forum.arcadecontrols.com/index.php?topic=82468.0

[Franco B]

After reading your review I see Ultimarc does a 5v version too, I had a quick look at the product page when I saw the OP post and for some reason I only saw the 12v info

If you are using the 5v versions either tap 5v from your system or use the red 5v from a PSU molex.

[JohnnyD]

I have the 5 volt one actually

I'm trying to get it to run like this guy from here http://forum.arcadecontrols.com/index.php?topic=69968.200

I would like it to light up when activated, not have it run all the time.

After reading your review I see Ultimarc does a 5v version too, I had a quick look at the product page when I saw the OP post and for some reason I only saw the 12v info

If you are using the 5v versions either tap 5v from your system or use the red 5v from a PSU molex.

[JohnnyD]

bump

[Kaytrim]

Hey Johny my PM to you must have gotten lost.  I have been in Lima, Peru the last 2 1/2 weeks so my internet connection hasn't been all that good.  I am back home in the states so shoot me an email to kaytrimskustoms@gmail.com and I'll get you set up with the 12 button version of my board.

TTFN 
Kaytrim

p.s. Thanks Franco...