Author Topic: WG K7000 (Read 1333 times)

jaav · « **on:** June 21, 2008, 10:56:50 am »

I have a K7000 that failed some time ago, replaced the reg, LOT and driver Has been fine, the tube is alittle low on emission, anyway it started to develop a vertical fault so i did a recap. No more vert problems but now I have a horizontal convergence problem the 3 guns are way out.
in cross hatch mode the vert is nice and white but the horizontal you can see each RGB.
Ive rechecked the caps.

any clues What I may have done wrong.

Thanks Jim. broome WAust...

grantspain · « **Reply #1 on:** June 21, 2008, 11:07:30 am »

maybe you knocked the purity rings on the yoke whilst removing the chassis,they should all line up to a paint line

Ken Layton · « **Reply #2 on:** June 21, 2008, 01:15:04 pm »

Yup, you must have bumped the yoke or the purity/convergence rings on the neck.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: WG K7000 (Read 1333 times)

jaav

WG K7000

grantspain

Re: WG K7000

Ken Layton

Re: WG K7000