Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Can you identify this part on the Sanyo 20EZ?  (Read 1362 times)

0 Members and 1 Guest are viewing this topic.

cornishHen

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 99
  • Last login:February 08, 2016, 08:32:23 pm
Can you identify this part on the Sanyo 20EZ?
« on: March 07, 2008, 11:35:26 pm »
I was just tidying up a cinelabs flyback install when this large white part sheered.  I was gently wiping the dust from the top of it.  Any idea what this is?  A resistor?   
Logged

SirPeale

  • Green Mountain Man
  • Global Moderator
  • Trade Count: (+23)
  • Full Member
  • *****
  • Offline Offline
  • Posts: 12963
  • Last login:August 04, 2023, 09:51:57 am
  • Arcade Repair in New England
    • Arcade Game and Other Coin-Op Projects
Re: Can you identify this part on the Sanyo 20EZ?
« Reply #1 on: March 08, 2008, 05:38:36 am »
Yes, a resistor.
Logged

cornishHen

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 99
  • Last login:February 08, 2016, 08:32:23 pm
Re: Can you identify this part on the Sanyo 20EZ?
« Reply #2 on: March 08, 2008, 01:17:52 pm »
After alittle research I think this is 180Ohm 20watt Wire wound resistor..
Logged

cornishHen

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 99
  • Last login:February 08, 2016, 08:32:23 pm
Re: Can you identify this part on the Sanyo 20EZ?
« Reply #3 on: March 08, 2008, 01:29:00 pm »
is it ok to substitute a higher wattage wirewound resisistor?   Ex.  I have a 180ohm 20W resistor and i was hoping to substitute it with a 180ohm 25 watt?

Logged

Kevin Mullins

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 4504
  • Last login:February 01, 2021, 01:29:34 pm
    • Me on Myspace
Re: Can you identify this part on the Sanyo 20EZ?
« Reply #4 on: March 08, 2008, 02:48:17 pm »
Yes..... just as long as the ohm is correct.
The wattage is how much current the resistor can handle.
And make sure that it stands off from the pcb the same way due to heat buidup.
Logged
Not a technician . . . . just a DIY'er.
Pages: [1]
  
Go Up
« previous next »